The Radial Engineering X-Amp 500 Reamper Module is part of the 500 Series and lets you take a pre-recorded guitar track and send it back to amplifiers and effects so that you can tailor the sound to suit. Reamping allows the guitarist to only concentrate on the performance while recording. Working out specific sounds and optimal microphone placement can be done later. This eliminates hours of tiresome repetition, while allowing the producer to adjust the character of the track as the production evolves.

The X-Amp is easy to use with its plug-n-play feature. The design begins with an XLR balanced line level input located on the 500 series rear panel that feeds the X-Amp. To ensure high fidelity, a 100% discrete class-A circuitry is employed. The X-Amp unbalances and buffers the pre-recorded signal where it then feeds two transformer-isolated hi-Z guitar level outputs. The ¼" jacks are front-mounted for desk-top convenience and equipped with ground lifts to help eliminate hum and buzz caused by ground loops. Independent level controls enable you to adjust the drive going to each amp for optimal tone. In case one of the amps are out of phase, then depressing the 180º quickly brings both in line.

Separate output controls make it easy to set the guitar amplifiers to a suitable level from the control room. A 180° polarity reverse assures that both the amplifiers will play in phase. In use, the X-Amp enables the user to take a pre-recorded track and send it simultaneously to two amplifiers. This makes it easy to optimize the track to best suit the recording. The guitar cables can be extended to 50’ (15m) without noise. Reamping is often used on guitars, bass, and keyboards to create effects, thicken the tone, or simply replace poorly recorded tracks.